Veo Pan and Tilt Manual de usuario descargar pdf (Pagina 16)

To change the screen display mode

1. Using remote control, press the DISP button; using Veo 120XXN front panel, press DISPLAY button or

right-click on the main screen and select DISPLAY option from the context menu. The display will change

to a single-channel display.

2. Repeat step 1 until the desired screen display appears.

To view a specific channel, press the corresponding channel button on the Veo front panel or on the

remote control. Please refer to the Remote Control section on page 12 for more information.

SEQUENCING MODE

Default sequencing mode allows rotating all available channels in the full screen mode on the main

screen. Additional custom sequencing modes may be created in Display Menu.

To select Sequencing Mode, right-click on the Main Screen and select SEQUENCE option from the

context menu or press SEQUENCE button on the remote controller.

The sequencing dwell time determines how long each channel (screen display) will be displayed on the

screen. The default dwell time for sequencing mode is set to 3 seconds. The default sequencing dwell

time can be changed in the Display -> Monitor menu.

ADJUSTING MENU SETTINGS

To access menus on the Veo 120XXN, press the SETUP button on the front panel/remote control or

right-click on the main screen and select SETUP from the context menu. Select GENERAL from the

main menu screen. Each menu contains settings related to a different function on the Veo 120XXN.

These menus are described below.

NAVIGATING VEO SETUP

To navigate the menus and sub-menus, use the mouse, ARROW buttons on the front panel of the unit

or on the remote control.

Use the USB mouse (with supported models only) for the complete ease of navigation. To enter the

sub-menu or click a button on the user interface, click it with the mouse cursor or select it and press

the ENTER button on the front panel/remote control.

Figure 16. Main Menu

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Sin comentarios

Veo Pan and Tilt Manual de usuario Pagina 16