Veo Pan and Tilt Manual de usuario descargar pdf (Pagina 18)

MONITOR

•

Sequence Dwell: Set the time interval that each camera/screen division will be displayed before the

Veo 120XXN switches to the next video input in sequence. This setting is used when the sequence

display mode is used in live mode. Sequence dwell time can be configured between 1 and 60

seconds. This setting applies to the monitors that can be connected to the VGA OUT, MONITOR

OUT (BNC) and SVHS (S-Video - Veo 12004N only) ports in the back of the system.

•

Spot-Out Dwell: Set the time interval that each camera will be displayed on the spot monitor

before the Veo 120XXN switches to the next video input in sequence (1-60 seconds). This setting

applies to the monitors that can be connected to the SPOT OUT (BNC) port in the back of the

system.

•

De-Interlace Mode: Turn this setting ON to remove the screen spread if you are recording at a high

resolution (704 x 480) and a low frame rate.

•

Alarm Pop-up Mode: Turn this setting ON to display the corresponding camera in the full screen

mode each time the alarm is triggered. For example, if Alarm Input #1 is triggered, Camera 1 is

displayed in the full screen mode. This setting does not affect the spot monitor display.

•

Alarm Pop-up Dwell: Set the time interval that the Alarm Channel will remain in the full screen

mode (1-60 seconds).

•

Motion Pop-Up Mode: Turn this setting ON to display the corresponding camera in the full screen

mode on the VGA OUT and MONITOR OUT displays each time the motion is detected. This setting

does not affect the spot monitor display.

•

Motion Pop-up Dwell: Set the time interval that the Motion Channel will remain in the full screen

mode (1-60 seconds).

SEQUENCE

Each Veo 120XXN comes with a default sequence, which displays each connected channel in a

sequential order in a full screen mode. The user can create additional custom sequences in the Display

Sequence menu. To create a new sequence, click the ADD button. The ADD window will be displayed.

Double-click inside the SEQUENCE TITLE to enter the new name for the sequence. In the ACTIVATION

field, you may enable your new sequence. Only one sequence can be enabled at a time. Click SAVE to

start programming your new sequence on the screen. You may choose any number of positions for your

new sequence; you may also select any screen display mode for any of the sequence positions.

Once you have completed programming the new sequence, SAVE & CLOSE out of the programming

window. The new sequence will then be added to the Display Sequence Menu. To edit or delete a

particular sequence, double-click it on the list to display the EDIT window.

Figure 18. Monitor Display Menu

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

Sin comentarios

Veo Pan and Tilt Manual de usuario Pagina 18